84
Appendix H
Advanced NMEA Setup
Advanced NMEA Setup Page
NMEA Interface
If you are going to interface the GPS 152 with another piece of equipment (such as a radar or
autopilot), the unit needs to be set to output NMEA data. The NMEA data can be customized to
shorten the update time from the unit. If too many NMEA sentences are activated, the unit may take
longer than two seconds to update.
To activate the NMEA data:
1. With the GPS 152 turned on, press
MENU
twice to display the Main Menu. Use the
ARROW
KEYPAD
to select the Com tab.
2. Highlight the ‘Serial Data Format’ fi eld and press
ENTER/MARK
.
3. Select ‘NMEA In/NMEA Out’ and press
ENTER/MARK
.
Advanced NMEA Output Setup
The GPS 152 NMEA data transmission can be customized to keep the output rate at two seconds.
If the unit is set up to output all of the available NMEA sentences, the output rate may exceed two
seconds. The ‘Advanced NMEA Output Setup’ page will allow you to turn on/off the GPS Status (GSA,
GSV), Waypoint/Route (WPL, RTE) and the GARMIN Proprietary sentences. You can also change the
precision of the Lat/Lon minutes.
To set up the Advanced NMEA Output:
1. With ‘NMEA In/NMEA Out’ selected, press
MENU
. Select ‘NMEA Setup’ and press
ENTER/MARK
.
2. To turn a fi eld On/Off, place the highlight over the desired fi eld and press
ENTER
. Make a selection
and press
ENTER
again to accept the selection.
GPS 152 NMEA Sentence Output (NMEA Version 2.3 compliant)
Always transmitted:
GPRMC, GPGGA, GPGLL, GPBWC, GPVTG, GPXTE, GPRMB
Switchable sentences:
GPGSA, GPGSV, GPWPL, GPRTE
GARMIN proprietary:
PGRME, PGRMZ, PGRMM
152 Manual Part 2.indd 84
11/27/2002, 2:56:57 PM
