G1000/GFC 700 Post Installation Checkout Procedure – Hawker / Beechcraft King Air C90
Page 2-19
190-00682-00
Revision 5
2.13
Aircraft Registration Number Entry
1. If not applied, apply power to the G1000 system.
2. With PFD1 in configuration mode, select the GTX page group, then select the
TRANSPONDER
CONFIGURATION
page on PFD1.
3. Select or verify selected,
XPDR1
is in the SELECT TRANSPONDER window.
4. Ensure that the ‘
ADDRESS TYPE’
is ‘
US TAIL
’ under the ‘
SET’
and ‘
ACTIVE’
columns.
5. Activate the cursor and highlight the ‘
ADDRESS’
field. Use the small/large FMS knobs to enter
the aircraft registration number.
6. Once the correct registration number is entered, press the
ENT
key. The transponder is
configured:
7. Observe the status window.
8. Press
the
ENT
key on PFD1 to acknowledge prompt.
9. Verify
FLIGHT ID TYPE = SAME AS TAIL
under
SET
and
ACTIVE
columns.
10. After the #1 transponder configuration is complete, use the cursor to select
XPDR2
and repeat
Steps 2 –8.
11. After completing XPDR2 configuration, deactivate the cursor.
2.14
Terrain/Obstacle Database Loading
1. Open PFD1, PFD2 and MFD circuit breakers.
2. Insert an SD card containing current Terrain/Obstacle database cards into the lower slots of
PFDs and MFD. Refer to the General Arrangement drawing for correct card part numbers.
3. Close PFD1, PFD2 and MFD circuit breakers.
