Garland STARFIRE SENTRY STW286, Инструкция по установке и обслуживанию

Страница: 7 / 20

P151 Rev. 1 (03/05) Page 7
B. The front casters on the appliance are equipped
with brakes to limit the movement of the appliance
without placing any strain on the connector or
quick disconnect device or its associated piping.
C. Be aware; required restraint is attached to a bracket,
which is located on the rear caster closest to the
gas connection. If disconnection of the restraint is
necessary, be sure to reconnect the device after the
appliance is returned to its original position.
Ventilation & Air Supply
Proper ventilation is essential for optimum performance.
The ideal method of ventilating equipment is the use
of a properly designed canopy which should extend six
inches, (152mm), beyond all sides of the appliance(s) and
six feet, six inches, (1981mm), above the floor.
A strong exhaust will create a vacuum in the room. For
an exhaust vent to work properly, replacement air must
enter the room. The amount of air that enters must equal
the amount exhausted. All gas burners and pilots need
sufficient air to operate. Large objects should not be
placed in front of the appliance(s) which would obstruct
the flow of air into the front.
Mounting Instructions for Backguards
A. Rear of range must be easily accessible.
B. Remove the flat-head bolt “A” from each side of
the backguard only when the unit will be placed
against another appliance with a backguard, shelf,
or broiler.
C. Place the backguard on the rear of the range,
slipping the support brackets into the openings in
the burner box sides.
D. Securely fasten the support brackets to the burner
box sides with (4) 1/4-20 x 3/4 slot truss head
machine screws, or (4) #10B x 1/2 Phillips sheet
metal screws. (Hardware package is supplied).
E. Remove front panel.
F. If the appliance is banked with others that have
backguards installed, replace the flat head bolts
removed in Step B so that the upright of the
backguard is fastened to upright of the adjacent
backguard.
G. Replace the front panel(s).
Upright
Burner Box
Side
1/4" x 3/4"
Type "B"
Washer Hex
Head SMS
4 Req'd
Bolt "A"
Electrical Connection
For 120 volt usage, a cord and plug is provided but
connection to the electrical service must comply with
local codes; or in the absence of local codes, with
the Canadian Electrical Code C22.1, (latest edition),
or with the National Electrical Code, ANSI/NFPA
No. 70 (latest edition).
Warning: Electrical Grounding Instructions
This appliance is equipped with a three pronged
(grounding) plug for your protection against shock
hazard and should be plugged directly into a properly
grounded three-pronged receptacle. Do not cut or
remove the grounding prong from this plug.
Power Failure Note : In the event of a power failure,
no attempt should be made to operate this oven. This
oven is gas operated but has electrical features, motor
and door switches.
INSTALLATION continued