Garland STARFIRE SENTRY STW286, Инструкция по установке и обслуживанию

Страница: 12 / 20

P151 Rev. 1 (03/05) Page 12
3. Wipe exposed cleanable surfaces with a mild
detergent and hot water. Stubborn residue may be
removed with a lightweight non-metallic scouring
pad. Stainless steel areas should be washed with
a mild detergent, hot water and a soft cloth. If
necessary to use a non-metallic scouring pad always
rub in the direction of the grain in the metal to
prevent scratching. NEVER USE STEEL WOOL.
4. Check the operation of the flame safety device by
closing the gas supply during burner operation.
Listen for the flame failure valve on the combination
gas control “clicking” closed. This action must
occur within 1 second of extinguishing the main
burner flame.
MAINTENANCE & CLEANING continued
5. Clean the oven racks, shelves and guides with hot
soapy water and dry thoroughly. Clean the oven
interior with a propriety oven cleaner following the
manufacturers instructions.
6. Inspect the rear exhaust fan filter weekly. If upon
inspection the filter appears dirty it can be cleaned
with hot water and dish detergent. The filter screen
covering the filter on the rear panel via clips top and
bottom and easily snaps on-off.
CONVERSION INSTRUCTIONS
Servicing must be carried out by a competent person in
accordance with the law.
WARNING: Turn off the gas supply to the appliance
at the service cock and the electrical mains before
commencing any servicing work.
IMPORTANT: Test for gas leakage on completion of
any servicing work.
The following instructions are intended to describe
the operations necessary to convert equipment from
operation on one gas to another.
1. Ensure that all of the parts necessary to make the
conversion have been supplied as follows:
a. Injector fittings ( One required for each main
burner & one required for each pilot)
b. Regulator, (one per unit )
If any of the required parts are missing, contact
your Garland dealer before attempting to carry out
the conversion.
2. Remove the burners following the instructions
given in this manual.
3. Replace each injector fitting with the new fitting
that is supplied.
NOTE:
Before doing so, refer to Table C in this
manual to ensure that the correct injector has been
supplied for the gas supply being converted to.
4. Replace the spring in the governor with the new
spring supplied.
Upon completion of all the above operations, follow the
section in the manual on “Commissioning” and ensure
that the setting pressure and all burner flame settings
are adjusted accordingly.