Garland STARFIRE SENTRY STW286, Инструкция по установке и обслуживанию

Страница: 15 / 20

P151 Rev. 1 (03/05) Page 15
Gas Control Valve
1. Remove the fastener securing the control
compartment access panel.
2. Slide out the control drawer.
3. Remove the main body side panel to access the gas
train.
4. Break the pipe union connection at the inlet of the
gas control and the add 7/16” union connection
located at the outlet of the control.
5. Remove the wires from the connections to the gas
valve. Be sure to note which wires connect to which
terminal before doing so.
7. Replace the control and reassemble in the reverse
order.
Motor
1. Open the oven doors.
2. Remove the oven racks and guides
3. Remove the two (2) wing screws securing the fan
guard and remove the guard.
REPLACEMENT OF PARTS continued
4. Using an allen head wrench loosen the screw
securing the blower wheel to the motor shaft and
remove the wheel.
5. Remove the four (4) screws securing the motor
mount plate to the oven casing back and pull the
plate forward into the oven compartment.
6. Disconnect the motor wire connections (note which
wire connects to which) and replace faulty motor.
8. Reassemble in the reverse order.
Ignition Control
1. Remove the fastener securing the control
compartment access panel.
2. Slide out the control drawer to access the lamp.
3. Disconnect the supply wires to faulty ignition
control (noting the wire connections)
4. Replace the faulty control.
6. Reassemble in the reverse order.