Operating Instructions
RTCSmp Built-In Temperature Controlled Hold-Line
Part # 4532287 Rev 2 (1/20/14)
19
6.3
Temperature Control and Display
6.3.1
Configurations and Temperature Control
One RTCSmp HOIN induction generator can control up to four heat retaining plates. Hence, four configurations
are available, ranging from one to four heat retaining plates. For each configuration, one temperature control
switch controls up to two heat retaining plates. When two heat retaining plates are connected to one switch, both
plates would be set to the same set temperature.
Model
Configuration
(Heat Retaining Plate(s), Control Switch(s), and
Induction Generator are shown)
HOIN800
One switch controls one heat retaining plate.
HOIN1600
Two switches; each controls only one heat
retaining plate.
HOIN2400
Two switches; one switch controls one heat
retaining plate and the other switch controls two
plates.
HOIN3600
Two switches; each controls two heat retaining
plates.
6.3.2
Set and Current Temperatures
Set the desired temperature by turning the control knob and the unit is
immediately ready
for operation. You
can adjust the temperature in an increment of 5
o
F (1
o
C), from 122-212
o
F (50-100
o
C). The digital display
underneath the Ceran glass shows the set temperature initially and then followed by the current/actual
temperature.
ON-Position
Any position where
“0”/Line is not
pointing straight up.
OFF-Position
“0” / Line is pointing
straight up.
