Installation
RTCSmp Built-In Temperature Controlled Hold-Line
10
Part # 4532287 Rev 2 (1/20/14)
4.4.1.2
Cut-Out Dimensions
See
Detail A
in section
4.4.1.1
:
A.
Cut-out dimension on the counter surface: 528 x 328 mm [20.79” x 12.91”].
B.
Recommended recess depth: minimum 8.00 to 8.64mm [0.315”to 0.34”].
C.
Body Clearance (width x depth x height): 300 x 500 x 100mm / 11.81” x 19.69” x 3.94”.
4.4.1.3
Parallel Installation and Clearance
NOTE
The information provided below can only be used as a general guideline. Designers must consult their
countertop suppliers when designing the appropriate support structure and clearance for the
countertop and the installation.
There is no clearance requirement for installing multiple RTCSmp
HOIN Heat Plates side by side. However, for structural strength and
protection against water penetration, we recommend the
followings:
•
For stone countertop, keep a minimum gap of 4”
[101.6mm] between cut-outs and provide reinforcement
beam in between units.
•
For other countertop materials, the glass-tops can be put
side by side, and the joints between glass-tops must be
water-tight, silicone sealed.
The Heat Retaining Plates can be installed in a variety of arrangements. Some examples are:
•
(
A
) and (
B
): The plates are placed in a row, with or without gaps in between plates.
•
(
C
) and (
D
): The plates are arranged in a rectangle, with or without gaps in between.
4.4.1.4
Installation Steps
NOTE
Please pay attention to the orientation of the unit. All the connectors for installation and service are
located at the front of the unit. The digital display under the glass is also at the front.
A.
The connectors are located at the FRONT of the unit.
B.
The digital temperature display underneath the
Ceran glass is located at the CENTER FRONT of
the unit.
IMPORTANT
To protect the induction unit from water penetration, you must apply and bond the silicone
adhesive properly to create a water-tight seal. Before you begin the installation, it is very
important to use isopropyl alcohol (minimum 70%) or equivalent to clean the flange and
the counter surfaces where the silicone adhesive will be applied.
