![background image](http://html1.mh-extra.com/html/garland/gxc24/gxc24_installation-operating-and-service-instructions_564370006.webp)
Part # 9229077 (07/05)
Page 6
INTRODUCTION
Garland manufactures the GX Series Char-Broilers with
two different types of radiants, with widths ranging from
24” to five feet. While service and customer operation
may vary from model to model, installation is similar
throughout the line.
All units are shipped completely assembled, with the
loose parts secured in place with masking tape or tie
cords, and the pressure regulators (and ceramic coals, if
applicable) packed inside the unit. All units are adjusted,
tested, and inspected at the factory prior to shipment.
IMPORTANT: After uncrating, immediately check
the equipment for visible signs of shipping damage.
If such damage has occurred, do not refuse shipment,
but contact the shipper and file the appropriate freight
claims.
Rating Plate
The rating plate is attached to the Char-broiler’s body on
the left hand inside wall at the lower front. It is accessible
after opening the front apron door.
Information on this plate includes the model and serial
numbers… when communicating with the factory about
a unit or requesting special parts or information, this data
is essential for proper identification. Other information
on this plate is the BTU/hr input to the burners, outlet
gas pressure in inches WC, and whether orificed for
natural or propane gas.
In the event you have any questions concerning the
installation, use, care or service of the product, write or
call our Product Service Department.
WARNING: All Garland Char-Broilers must be
connected only to the type of gas identified on the rating
plate!
INSTALLATION
General Installation
IMPORTANT: Safe and satisfactory operation of your
equipment depends, to a great extent, on its proper
installation. Installation must conform to local codes
or, in the absence of local codes with the National Fuel
Code, ANSI Z223.1 Natural Gas Installation Code,
CAN/CGA –B149.1, or the Propane Installation Code,
CAN/CGA-B149.2, as applicable.
. Installation of the equipment should be made by a
licensed plumber.
2. A manual gas shut-off valve must be installed in the
gas supply line ahead of the appliance for safety and
for ease of future service.
3. A gas pressure regulator must be installed at the
appliance prior to connecting the equipment to the
gas line. Failure to install a regulator will void the
equipment warranty.
Clearances
GXC / GXR Series
The appliance area must be kept free and clear of all
combustibles. Adequate clearance must be provided for
air openings into the combustion chamber and for proper
air supply.
These units are design-certified for the following
installations:
. Intended for other than household use.
2. For use in non-combustible locations only.
3. For use with 4” (minimum) legs.
COMBUSTIBLE
CONSTRUCTION
NONCOMBUSTIBLE
CONSTRUCTION
Rear
6” (152mm)
Rear
0”
Sides
6” (152mm)
Sides
0”
Содержание GXC24
Страница 2: ...Part 9229077 07 05 Page ...
Страница 11: ...Part 9229077 07 05 Page 11 NOTES ...
Страница 12: ......