Gardsman CTC-1745, Руководство по установке

Страница: 14 / 55

12
1. Telephone Number
CTC-1745 IP Panel has GSM Dialer for Reporting selection served as a back-up. A
selection of sending CID codes (via DTMF) or SMS text Message to Monitoring Center
is available. The maximum length of a number is 30 digits including
¿
& # . Account
Number
2. Account Number
Enter the Monitoring Center Server’s Account Number. A maximum of 4 or 6 digits
(depend on the Monitoring Center) can be entered.
Account Number #1 & #2 should be programmed corresponding to Telephone Number
#1 & #2.
3. Format
DTMF – CTC-1241 will send Contact ID (CID) codes to Central Monitoring Station
(CMS) in DTMF format. (4- or 6-digit account number must be entered.) For
Example, when the Wrist Transmitter (WTR) or Emergency Pendant is pressed, the
Contact ID event code (101) will be sent.
SMS / Text – When 4-digit account number is entered, CTC-1241 will send Contact
ID format reporting to CMS SMS Receiver.
If the account number has not been entered, the Control Panel sends SMS text
message for reporting. For example, (Area1 Panic Alarm)
4. Priority:
(1) First Priority: The system must report to this Tel. number first (in priority order) and
successfully.
If more than one set of Tel. number and/or IP address is set as first priority, all of
them must be reported, and all reporting must be successful.
(2) Second Priority: For back-up reporting. The system excutes the reporting based
on your setting for back-up method (see section Back-up Method ).
<
<
I
I
M
M
P
P
O
O
R
R
T
T
A
A
N
N
T
T
N
N
O
O
T
T
E
E
>
>
)
The reporting via IP connection is always in higher priority than reporting via GPRS,
then, the Telephone Numbers.
(a) If all IP, GPRS & Telephone numbers are set as either First Priority or Second
Priority, the reporting will start with IP first.
(b) If IP is set as First Priority and GPRS or Telephone number are set as Second
Priority, the reporting will start with IP first.
(c) If IP is set as Second Priority whereas either GPRS or Telephone number are
set as First Priority, and then the reporting will start with First Priority first.
z
Report Setting
1. Back-up
This feature is only required if any IP, GPRS and/or Telephone Number are set as
Second Priority reporting source when they were programmed.