Gardner Denver Reavell 5236, Руководство по эксплуатации и техническому обслуживанию, Страница: 106 / 134

APP 090D THERMOMETER SWITCHES
Page 1
THERMOMETER SWITCHES
These thermometer switches are set to the figures quoted below, the following information is for setting
information only, if the temperature switch has to be replaced or re-adjusted.
If the switch needs to be re-adjusted due to a higher ambient temperature or any reasons please contact
Gardner Denver ltd for more information.
•
TO SET TRIP INDICATOR POINTER
1. Run compressor to establish normal running temperature of black pointer [A].
2. When reading is stable, remove adjusting key [B] from rear of switch and insert into front of central
knob adjuster [C].
3. Rotate key to adjust red pointer [D] to 10°c above running temperature pointer [A].
4. Adjustment of trip pointer must be within range that has been pre-set at Gardner Denver ltd before
despatch, but may be adjusted within this range depending on ambient conditions.
Note: do not reset temperature controller setting if it trips, always locate and correct possible fault before any
attempt is made to alter setting.
Contact Gardner Denver ltd engineering department for more information if the compressor trips when switch
is set at maximum value.
CONTROLLER
PART No
TRIP POINTER
STOP SETTING °C
USED ON
COMPRESSOR MODEL
C202556.1 125 5236.1
C202556.2 140 5212
C202556.3 150 5336,5415
C202556.4 155 5215 & 5217
C202556.5 170 5236.2,5315
C202556.6 180 5415E5317,5417.5417N
C202556.7 205 5436(CU TUBES)
C202556.8 220 5436.1 &.2,5436H,5436N,5436SN & 5437
C202749.1 200 5280
C202749.2 210 5280
C202749.3 175 5409
C202960.1 75 WATERCOOLED M/C’S DELIVERY
C202960.2 60 5211
B
C
D
A