RB-7-100 Page 17
SECTION 3
LUBRICATION
FIGURE 3-1
– LUBRICATION
DRIVE END LUBRICATION (For Dual Splash Lube Blowers)
At the drive end, the bearings are lubricated by the slinger, which must be on the lowest rotor when in a vertical
configuration.
Approximate oil sump capacities are listed in Figure 3-2.
NOTICE
Machines are shipped without oil in the sump. Do not operate before adding lubricant.
Lubrication Instructions
Filling procedure
Refer to Figure 3-1. Remove the breather (B) from the drive cover. Add oil to the drive sump until oil reaches the
center of the oil level gauge (C). Secure breather (B) in the drive cover.
Add fresh oil as required to maintain proper level. The oil level should be at the middle of the sight glass when
the machine is not operating. Refer to Figure 3-2, for approximate oil capacities.
A. OIL DRAIN PLUG
B. BREATHER/OIL FILL
C. OIL LEVEL GAUGE
Содержание RBS 15
