Gardner Denver ELECTRA-SCREW EDEQHH, Руководство по эксплуатации и обслуживанию

Страница: 35 / 53

13–8–610 Page 27
SECTION 5
LUBRICATION
OIL COOLER, OIL FILTER & SEPARATOR
FIGURE 5–1 – FLOW DIAGRAM – AIR–OIL SYSTEM
204EDE797
(Ref. Drawing)
COMPRESSOR OIL SYSTEM (FIGURE 5–1) cools
the compressor, lubricates moving parts and seals in-
ternal clearances in the compression chamber.
The oil inlet line is connected at the bottom of the oil res-
ervoir. Air pressure in the oil reservoir forces oil through
the oil cooler, thermostatic mixing valve, oil filter and
into the compressor main oil gallery.
The oil passes through internal passages for lubrica-
tion, cooling and sealing. The air–oil mixture is then
discharged to the oil reservoir where a large part of
the entrained oil drops out of the air stream; the air
then passes through the final oil separator where most
of the remaining oil is removed. The separated oil is re-
turned to the compressor and the air passes to the final
discharge line.
RECOMMENDED LUBRICANT – Gardner Denver
R
compressors are factory filled with AEON
t
lubricants.
These lubricants are formulated to the highest quality
standards and are factory authorized, tested and ap-
proved for use in rotary screw compressors. AEON
t
lubricants are available through your authorized Gard-
ner Denver compressor distributor.
OIL SPECIFICATIONS – The recommended com-
pressor lubricant is Gardner Denver AEON 4000 Lubri-
cating Coolant which can be used for year–round op-
eration except as noted in the “High Temperature
Operation” paragraph below, or low temperature, see
“Installation for Cold Weather,” page 10.
AEON
t
4000 Lubricating Coolant is a superior petro-
leum base lubricant formulated and containing addi-
tives for use in Gardner Denver compressors.
Specific AEON lubricants are recom-
mended for use in this equipment.
Other lubricants may cause exces-
sive carryover or compressor dam-
age. Do not mix different types of lu-
bricants or use inferior lubricants.