To tilt the motor unit:
0°
15°
30°
45°
60°
-15°
-30°
-45°
-60°
u
5
For cutting at high and low level, the motor unit
5
can be tilted at
an angle of 60° to – 60° in 15° increments.
1. Keep the orange button
u
pressed.
2. Tilt the motor unit
5
in the required direction.
3. Release the orange button
u
and allow the motor unit
5
to engage.
To extend the telescopic
pipe:
45cm
4
e
For cutting at high and low heights, the telescopic pipe
4
can be
continuously extended by up to 45 cm.
1. Loosen the orange nut
e
.
2. Extend the telescopic pipe
4
to the required length.
3. Tighten the orange nut
e
again.
5. MAINTENANCE
1
3
2
DANGER! Risk of physical injury!
Cut injury when the unit starts accidentally.
v
Before you maintain the unit, make sure that the mains
cable is disconnected and the protective cover
1
is slid
over the bar
2
and the snap fit
3
is closed.
To clean the pruner:
DANGER! Electric shock!
Risk of injury and risk of damage to property.
v
Do not clean the unit with water or with a water jet
(in particular high-pressure water jet).
1. Clean the unit with a damp cloth.
2. Clean the airflow slots with a soft brush (do not use a screwdriver).
3. Clean the bar
2
with a brush, if necessary.
To replace the chain:
a
DANGER! Risk of physical injury!
Cut injury due to the chain.
v
Wear safety gloves when replacing the chain.
When the cutting performance reduces significantly (dull chain), the
chain must be replaced. The Allen key for the screws
a
is situated
inside the protective cover
1
. Only the original GARDENA Spare
Chain and Bar Art. 4048 or Spare Chain Art. 4049 can be used.
9
GB
