9
Assembling the chain bar and chain
Warning! The saw chain has very sharp edges, use thick protective
gloves for safety.
1.
Loosen the cover nut (20), remove the SDS control system and chain
bar cover(18).
Please note that the oil sealing plate(17) must on the working head.
2.
Position the chain bar(24) onto the working head.
3.
Fit the saw chain (22) over the sprocket(15) and into the chain bar
groove. The cutters on the top of the chain bar should face toward the
chain bar tip, in the direction of the chain rotation. (Note: If the chain is
not properly fitted over on the sprocket, the chain saw will not work and
could cause serious injury).
4.
Replace the chain bar cover(18) and install the SDS control system.
Tighten the cover nut(20) finger tight only. The cover nut(20) is used to
fasten the cover. The chain tightening piece A(21) is fixed to the cover
nut(20). The chain tightening piece A(21) must coordination to the
chain tightening piece B(23) which is on the chain bar(24), the chain
tightening ring is used to tightening the chain. The chain bar must be
free to move by chain tightening ring(19)
5.
Adjust the chain tension by turning the chain tightening ring(19) until the
