11
webbing will enable to release the strap from pole chain saw quickly in
case of emergency.
Adjusting the cutting length
To adjust the cutting length, open the lock trigger of the telescopic tube(8),
and adjust to suitable height.
Attention: Don
’
t forget to lock the lock trigger of
the telescopic tube(8)
.
Adjusting the cutting angle
This pole chain saw is supplied with three cutting positions for different cutting
status, adjust the cutting head angle to fit the growth of the plant. Press the
rotating button(13) on the left and right of the working head, and make the
working head(14) revolve, until it snaps securely into place at one of the
three positions indicated by the notches.
Adding the chain bar lubricant
The pole chain saw is equipped with an oil automatic system. The Chain bar
and Chain must always be oil lubricated when working. Non-observance of
this will result in increased wear out on the bar and saw chain.
NOTE: The chainsaw is supplied with no chain oil added.
Lubricant oil level
should also be checked after every 10 minutes of use and refilled as needed.
