TR-RC1xx - User Manual
10.3.3 General commands
Any changes you make using Ethernet commands are not saved
permanently until you send the
AW
command.
Report the TR-RC firmware version
This command returns the firmware version ruining on the TR-RC.
For example, typing:
VR
returns
TR-RC120 (HW101) V001
Set the rating of a light
This command sets the current or voltage rating of the light:
VL1,v,c
Where:
v
= voltage rating (12 to 24)
c
= current rating (10mA to 2A for TR-RC120, 10mA to 10A for
TR-RC122)
Note:
If the light is current rated, set the voltage rating to 0; if it is
voltage rated, set the current rating to 0.
Set continuous mode
This command sets the output to continuous mode and allows the
brightness to be set:
RS1,s
Where:
s
= brightness as a percentage (0 to 100)
Set pulse mode
This command sets the output to pulse on a trigger input:
RT1,p,d,s,r
Where:
p
= pulse width in milliseconds (0.1 to 999)
d
= delay from the trigger pulse in milliseconds (0 to 999)
s
= brightness setting in percent (0 to 999)
r
= retrigger delay in milliseconds ( 0.1 to 999). This parameter
is optional and if not set, the minimum allowed retrigger
time is set.
Note:
An error message is returned if the brightness setting requires
a greater current than the maximum current output or if the
combination of pulsed width and brightness is not allowed under the
limitations of the unit.
—
32
—
