3 - INSTRUCTIONS FOR USE
100
08
00
18
The set value is permanently lit on the humidity display
and the relevant LED is turned on when the humidifica-
tion is activated.
If it is not activated the core probe display remains in a
fixed position. Pressing again the STOP key during the
cooking cycle. the cooking cycle is suspended.
All the set parameters are maintained.
The cooking time will restart from the suspended time.
The cooking cycle is resumed by pressing the
START/
STOP
key again maintaining the set parameters (pos-
sibly changed).
At the end of the cooking cycle:
The bell rings for 10 seconds or until the oven door is
opened and the oven is put in the OFF status.
Opening the door during the operation of the oven is
equivalent to pressing the stop key, but, when the door
is closed again, the oven resumes its operation automa-
tically.
TEMPERATURE KNOB
Adjustable from 0 °C to 270 °C
Temperature default value: 100 °C
During a cooking cycle the set values can be changed by
turning the temperature knob; at this point the display
flashes and the value setting operation is repeated.
COOKING TIME KNOB
Adjustable from 0.00 to 9.59
default value: 000
Selects the cooking time value in hours and minutes.
By increasing the time above 9.59 you enter the infinite
cooking mode and the display shows
INF
.
At this stage the oven works for an infinite time.
Conversely, by decreasing the time from the infinite coo-
king mode you return to the minimum time.
PREHEATING
By turning the knob anticlockwise below 0.00 you acti-
vate the preheating function.
Instead of the time the display shows the message “
PRE
”.
When you start the cooking by pressing the
START
key
the oven begins to work and once the set temperature
is reached, the oven bell rings until the door is opened,
the values are zeroed and the user is back at the initial
stage of value setting.
Turning the knob clockwise the value on the display
turns to 000, the preheating function is disabled.
HUMIDIFICATION / DRYING KNOB
Adjustable from 0 to 100
Default 00
The display flashes the default value 0, turning the knob
you set the value.
Turning the knob you turn on the humidification LED,
and you set the desired humidification percentage.
Turning the knob in the opposite direction once the va-
lue on the display is brought back to 0 the drying LED
turns on and the desired percentage of oven chimney
opening is set.
The higher the percentage, the more the chimney stays
open (100% total opening of the chimney).
HUMIDIFICATION KNOB
(only for the 523A model)
The display flashes the default value 0, turning the knob
you set the value. During a cooking cycle the set values
can be changed by turning the knob at this point the
display flashes and value setting is repeated.
INF
PRE
EN
