Note: If an attempt is made to start a pump and the pump size is not specified, this menu option
is automatically brought up and displayed. You must then set the pump size in order to start the
pump.
1.
After you press
Menu
, the top display shows PUMP1 SIZE.
2.
Press the
ENTER
key. The bottom display shows the current pump size in liters per
second (l/s), followed by a flashing sign to indicate that you may use the numerical
keys to enter the pump size.
3.
First use the backspace (
←
) key to overwrite, and then enter the desired pump size
with the numerical keys.
4.
Press
ENTER
to save the changes.
5.
Press the
Menu
key to select PUMP2 SIZE.
6.
Repeat Steps 2, 3, and 4.
1
2
3
4
5
6
7
8
Set Point
Set Point
Supply 1
Supply 2
1
2
3
4
5
6
7
8
9
ESP
0
ENTER
High
Voltage
Operate
Bake
Set
Points
TSP
Menu
Display
Select
Display
Select
2) Press ENTER.
3) Use backspace key to
overwrite and enter pump
size using numerical keys.
4) Press ENTER to save.
Supply 1
Display
Select
5) Press MENU to select
Pump 2.
6) Repeat steps 2 and 3.
1) Press MENU.
Figure III-7. Setting pump size.
Setting Preferences
Overview
Press the
Menu
key to cycle through the top menu selections until you reach PREFRENCES.
Press
ENTER
to step to its submenu. Press the
Menu
key to cycle through the following
submenu selections:
•
PRES UNITS
•
PUMP DSPLY DFAULT VAL
Press
ESC
to exit the submenu and return to PREFRENCES.
1
2
3
4
5
6
7
8
Set Point
Set Point
Supply 1
1
2
3
4
5
6
7
8
9
ESP
0
ENTER
High
Voltage
Operate
Bake
Points
TSP
Menu
Display
Select
2) Press ENTER.
3) Press MENU to cycle through these options:
- PRESS UNITS
- PUMP DSPLY
Supply 1
Display
Select
1) Press MENU until you reach PREFRENCES.
Top
Menu
Submenu
Figure III-8. Reaching PREFRENCES Submenu.
PRES UNITS
Digitel MPC Manual
Page 31 of 72