GAME AQUAQUIK 4510, Руководство пользователя

Страница: 20 / 28

20 SAVE THESE INSTRUCTIONS
9. FILtER oPERAtIoNS
Start Up
Once the filter system has been properly assembled, the sand chamber filled
with sand and the hoses connected, you may begin with filtration. However, we
recommend that you clean and prepare the new sand that is in the sand chamber
first. Cleaning the sand prior to filtering your pool will remove most of the dust
and tiny sand particles that may exist in the sand. If you move straight to filtering,
these particles will end up in your pool. To clean the sand, please follow the
instructions below.
Cleaning Sand
1. Make certain the pump is not plugged in to a power supply.
2. Start with the valve in the “5 - Closed” position.
3. If you haven’t done so already, fill your pool with water. Ensure that the water
level is at least 1 – 2 inches above the top of the hose intake and return ports
in the pool.
4. Release the shut off valve at the intake port in the pool. If you plugged the
intake port, remove the plug to allow the water to flow into the intake hose.
5. With the filter-pump system installed in a location level lower than your pool’s
water level – water will automatically flow into the pump-filter system.
6. Allow the filter tank to fill with water.
7. Check for leaks and make any necessary adjustments.
8. Follow the backwash process below.
Backwash Process
1. Disconnect the motor/pump from the power source.
2. Attach backwash hose (not included) to backwash port.
3. Place the multi-port valve in the “4 - Backwash” position.
4. Reconnect to power source.
5. Run filter in backwash mode until discharge water is clear.
6. Disconnect the motor/pump from the power source.
7. Place the multi-port valve in the “2 - Rinse” position.
cAUtIoN
See Power Source Requirements on page 11
8. Reconnect to power source.
9. Allow filter to run for 60 seconds to remove any remaining residue from pump
and valve.
10. Disconnect the motor/pump from the power source.
11. Place the multi-port valve in the “1 - Filtration” position.
12. Reconnect to power source.
Your filtration system is running and ready for further operation.