GAME AQUAQUIK 4510, Руководство пользователя

Страница: 22 / 28

22 SAVE THESE INSTRUCTIONS
Adding New Sand
• Protect bottom strainer while replacing or adding sand. Fill the tank with a
foot of water and cover the water chamber to avoid getting sand inside.
• Start filter in rinse mode for 1 – 3 minutes after initial start up or after
adding new sand. By doing this you can avoid blowing small particles and
impurities from the new sand into your pool. If some debris from the new
sand does go into your pool, vacuum it up with the system in purge mode,
otherwise you may keep sending it back to the pool.
cAUtIoN
Before loosening any threaded connections on the filtration system, be sure that the intake
and return hoses are closed or plugged to prevent water flow over the motor.
Cleaning the Hair and Lint Filter
1. Unplug the pump from the power source.
2. Close the shutoff valves or block the water flow at the pool inlet port.
3. Place valve in the “5 - Closed“ position.
4. Remove the hair & lint strainer cover on the pump by unscrewing the threaded
collar. Take out the strainer basket, clean it, and replace it. Replace the hair & lint
strainer cover and tighten the threaded collar. DO NOT OVER TIGHTEN.
5. Open the shutoff valves or unblock the water flow at the pool inlet port.
6. Place valve in the “1 - Filtration“ position.
7. Reconnect to power source.
ImPoRtANt
NEVER operate the pump without the hair and lint strainer basket in place – this can cause
damage to the motor and pump assembly.
Winterizing the System
1. Unplug the pump from the power source.
2. Close the shut off valves or block the flow of water at the pool inlet and return
ports.
3. Disconnect the filtration system from the pool, drain the tank and hoses.
4. Place the handle on the central valve in position “7- Winterize" to relieve the ten-
sion on the spring and internal valve components.
5. Store the filter system in a location protected from frost and freezing tempera-
tures.
Safety Notes
If there is any indication that safe operation is no longer possible, the device is to be
disconnected from the power supply and secured against accidental use.
This is the case when:
The device has visible damage •
The device no longer appears functional •
After long periods of storage in poor conditions •