Galvanic Applied Sciences 962-AGX, Руководство по эксплуатации

Страница: 42 / 100

Revision 1 42 9/10/2019
c) Alarms
Low Cell (ºC) - This parameter specifies the set point temperature, in degrees C (ºC),
which will cause a Low Cell Temperature fault. When the measured cell temperature falls
below this value, the analyzer is placed in a
Fault
condition. The relay outputs and Status
indicator are forced to ‘Fault’, and the Control indicator is forced to ‘Manual’.
There is a three (3) degree deadband imposed on this alarm. The alarm will clear when
the measured cell temperature rises to more than 3ºC above the set point. If at the time
of clearing, no other fault conditions exist, the analyzer will return to a normal operating
condition. The relay outputs and Status indicator will return to Normal and the Control
indicator will return to Auto. This value is typically 40
o
C.
Low Aux -
This parameter specifies the set point temperature, in degrees C (ºC), which
will cause a Low Auxiliary Device Temperature fault. When the measured auxiliary device
temperature falls below this value, the analyzer is placed in a Fault Delay condition. The
relay outputs and Status indicator are forced to
Fault
, and the Control indicator is forced
to
Manual
.
4.8.5 Network Sub Panel
The
Network
sub-panel is presented in Figure 4-13. The parameters on this sub-panel are set
during manufacturing and are not editable by the user.
The information under the
Network
column shows the connection data for the web GUI.
The information under the Direct Connect column shows the connection data for the laptop
Ethernet port.