Gallet MT 190, Инструкция по эксплуатации

Страница: 25 / 40

– The power cord must not be damaged with sharp or hot objects, open fire, it must not be
sunk into water or bent over sharp edges. Never put it on hot surfaces or do not let it hang
over the edge of a table or work tables. Hitting, stumbling or pulling the power cord e.g. by
children can result in tilting over or drawing the appliance down and serious injury!
– Prevent the supply cord to hang loosely over the edge of the working desk where
children could reach it.
– If you need to use an extension cord, it has to be uncorrupted and it has to comply with
the valid standards.
– Use the appliance only with original accessories from the manufacturer.
– Use the appliance only for the purpose it is intended for as specified in this manual.
Never use the appliance for any other purpose.
– WARNING : There is a risk of injury in case of incorrect use (not in accordance with the
manual) of the appliance.
– The manufacturer is not responsible for damage and injuries caused by improper use
of the appliance and the accessories (e.g. food deterioration, injury, cutting ) and its
guarantee for the appliance does not apply in situations when the safety warnings above
are not complied with.
Warning
If the blender runs idle (e.g. the blade cannot touch the ingredients), disconnect it from the
mains and release the ingredients. The blender cannot run idle for more than 10 seconds!
II. FEATURES OF THE DEVICE (Pic. 1)
A – propulsion unit
A1 – propulsion shaft A3 – supply cord
A2 – rotary knob A4 – carry handle
B – dish
B1 – plastic container base B2 – handle
C – lid
C1 – lid plug
III. PREPARATION FOR USE
Remove all packaging material, remove the accessory. Remove all adhesive foils, stickers
or paper from the appliance. We recommend washing the glass container before using it
for the first time. The knife section is treated with oil not harmful to health for technological
reasons. Therefore first fill in the container with warm water (max. 50 °C) with a small
amount of detergent. Then put the container on the food processor, set the maximum
rotational speed and run for 1 minute. Then rinse the container with clear water. Put the
blender with the selected accessories on a flat, stable, smooth and clean work surface
at the height of at least 85 cm, out of reach of children and incapacitated people. Make
sure that the power cord is not damaged and that it does not lead through any sharp or
hot surfaces. Plug power supply fork A3 to the electric power. Choose the amount of the
processed food so that the maximum volume of the containers marked with the gauge line
is not exceeded. Possible short-time mild smoke when the appliance is operated for the
first time is not a defect and the appliance is not subject to a complaint for this reason.
25
EN
/ 35