BOXFINDER (0001) User’s Manual
RSA “Galileosky”, LLC.
Page
20
10.4.
Command mode tab
This tab is intended to message a single command or a set of commands to the Tracker.
The command mode has the following buttons:
1)
Run commands;
2)
Run single command;
3)
Open from file;
4)
Save to file.
The commands will be identified whether you use capital or lower-case letters or both in turn.
Attention!
There are no spaces in command name!
Spaces between parameters are not allowed!
Commands and parameters are separated by space.
Commands are separated by Enter.
Single command example
An example of a command with a parameter:
Enter APN internet.beeline.ru,beeline,beeline as shown in the figure above and press
Run single command
button. The command and a response will be displayed in the Responses window.
Command: APN internet.beeline.ru,beeline,beeline
Response
:
GPRS: APN=INTERNET.BEELINE.RU, user=BEELINE, pass=BEELINE
To access the parameters in the Tracker memory you should use a command without parameters!
An example of a command without a parameter:
“APN” command
Request:
APN
Response:
GPRS:APN=INTERNET.BEELINE.RU, user=BEELINE, pass=BEELINE;
