GALAGAR GPS 3000 C, Техническое руководство по эксплуатации

Страница: 21 / 40

GPS 3000/4000 C 21
3.3.1 MIG MANUAL PROGRAM.
P2: SELECT MANUAL E1: ADJUST WELDING VOLTAGE E2: ADJUST WIRE SPEED
3.3.2. MIG SYNERGIC PROGRAM.
P2: SELECT PROGRAM P3:SELECT WIRE Ø E2: SELECT WELDING PIECE THICKNESS E1: CORRECTING WELDING VOLTAGE
3.3.3. PARAMETERS SETTING MODE. MIG/MAG PROCESSES.
P1: SELECT PROCESS P1: ENTER TO SETUP E1: SELECT CYCLE PARAMETER E2: ADJUST VALUE P1: SAVE PARAMETERS
(2”) (2”)
PARAMETER RANGE UNIT RESOLUTION RESET STD SPOT STD PULSE BIPULSE SPOT PULSE
L/D
Arc Dynamic -10 / +10 -- 1 0
MOD
Torch Mode
2T-4T-4TS
-- -- 2T
2TS
TON
Welding time 0,2-5,0 s 0,1 2,0
TOFF
Stop time 0,1-3,0 s 0,1 OFF
TC
Ignition time 0-500 Msg 1 100
FDC
Approach speed 10-100 % 1 30
TBB
Burn back time -20-+20 msg 1 0
TPR
Gas pre-flow time 0,0-3,0 s 0,1 0,3
TPS
Gas post-flow time 0,0-5,0 s 0,1 0,4
REF
Cooling unit mode OFF-ON-AUT -- -- OFF
DIM
Dimensional system mm-in -- -- mm
Restrictions mode 2T 4T 4TS 2T 4T 2T 4T 4TS 2T 4T 4TS 2T 2TS 4T
IS
Initial current 50-400 % 1 130
TS
Time IS 0,2-5,0 s 0,1 0,8
DWS
Current ramp-down time IS-IE 0,0-10,0 s 0,1 0,6
IEN
End crater current 10-200 % 1 50
CBP
Arc length correction Bipulse -30 +30 % 1 0
FBP
Frecuency Bipulse 0,5-5,0 Hz 0,1 3,3
DBP
Difference Bipulse 10-80 % 1 35
DCL
% Upper Intensity Bipulse 20-80 % 1 50
3.3.3.1. ACTIVATION COOLINIG UNIT.
P1: ENTER TO SETUP E1: SELECT REF E2: ADJUST ON-OFF-AUT P1: SAVE PARAMETERS
(2”) (2”)
AUTOMATIC: The cooling only works in welding mode and will switch off automatically 2 minutes after carrying out the welding
process.
ON : The cooling works permanently after the first welding process starts.
OFF: The cooling is deactivated. It enables to work with torches without water cooling.