Gaggenau VG 442, Руководство по эксплуатации, техническому обслуживанию и установке

Страница: 18 / 28

Important Notes
This appliance can be combined with all Gaggenau
Vario 400 Series appliances.
Please observe the general safety notes and the
important information in chapter 1.
The installing technician is responsible for
perfect functioning of the appliance at its installa -
tion location.
He must show the user how to switch off the
electricity and gas supply whenever required.
After unpacking, check the appliance for any
transportation damage and report this immediately
to the transportation company.
Note: Operation next to a downdraught
ventilator VL 430/431 is only allowed with the
air baffle LS 330-000.
Caution:
before connecting the appliance, please check
whether the
local connection conditions such as
gas type, gas pressure and mains voltage match the
appliance settings. This gas hob conforms to the
categories that are specified on the
rating plate .
The rating plate can be found on the appliance and
additionally on the quality control slip which is
included with these instructions. By replacing
nozzles, it is possible to set the appliance to any
gas listed on the rating plate.
If the data should not match, the appliance must
be changed over to the required gas type and the
available pressure.
As this gas hob is not intended for connection to an
exhaust gas system, pay attention to the applicable
installation conditions.
The appliance may be installed in kitchen
combinations made of wood or similar combustible
materials without taking additional measures.
The rear wall must consist of non-combustible
material.
A minimum distance of
100 mm
from heat-sensitive
items of furnishing or contact surfaces (cupboard
side panel) must be observed.
The hob conforms to appliance class 3 and must be
installed in the worktop as shown in the installation
sketch.
Do not install the appliance under a suspended
cupboard. For installation under a vapour extractor,
a minimum clearance of
650 mm from the top edge
of the pot stand to the bottom edge of the wall hood
must be observed. If several gas appliances are
installed, a larger distance from the extractor hood
might be needed.
Observe the installation manual of the extractor
hood. Wall trims must be heat-resistant, and the
minimum distance between the hob and the wall
trim is at least
35 mm .
The appliance must be installed and connected by
an authorised gas installer. The installation must
conform with all current regulations of the gas
supply companies and the regional construction
regulations.
Technical modifications reserved.
16
11. Installation Instructions