25
Note:
Temperature setting 100 °C provides efficient
cooking even if the water does not bubble very strongly
during the heating process. However, if you are not
satisfied with the boiling result, you can change the
boiling point setting.
Connecting the wireless temperature sensor to the
control panel
You will need to connect the wireless temperature
sensor to the control panel before using the cooking
sensor function for the first time.
To connect the wireless temperature sensor to the
control panel, follow the instructions below:
1
Select basic setting
™†
; see the section entitled
The
¨
symbol lights up white.
2
Press the
¨
symbol. A signal sounds and the
¨
symbol lights up orange. The hotplate indicators
light up white and the cooking sensor indicators on
the hotplates flash.
Press the
¨
symbol on the wireless temperature
sensor within 30 seconds.
3
Connection successful:
The wireless cooking
sensor is detected within a few seconds. Three
short beeps sound and the
¨
symbol changes from
orange to white. The cooking sensor indicators on
the hotplates go out.
Connection failed:
Five beeps sound. The
¨
symbol changes immediately from orange to white
and the cooking sensor indicators on the hotplates
go out.
▯
The cooking sensor function is made available once
the temperature sensor has been connected to the
control panel correctly.
▯
If there is a fault with the temperature sensor, the
connection may not be established correctly for the
following reasons:
‒
Bluetooth communication error.
‒
You did not press the
¨
symbol on the
temperature sensor within 30 seconds of
selecting a hotplate.
‒
The battery in the temperature sensor has run
out.
Reset the wireless temperature sensor and follow
the connection procedure once again.
▯
If the temperature sensor and the control panel are
not connected correctly due to a transmission error,
follow the connection procedure once again.
If no connection can be established, inform the
after-sales service.
Resetting the wireless temperature sensor
1
Touch and hold the
¨
symbol for approximately 8-
10 seconds.
While you are doing this, the temperature sensor's
LED indicator will light up three times. When the
LED lights up for the third time, it will start to reset
the temperature sensor. At this point, you will need
to lift your finger off the symbol.
Once the LED goes out, this means that the
wireless temperature sensor has been reset.
2
Repeat the connection procedure from point 2.
Programming
The hob must be on.
1
Attach the temperature sensor to the cookware, see
section
"Preparation and maintenance of the
2
Place the cookware with sufficient liquid in the
middle of the desired element and always put a lid
on.
3
Select the required hotplate using the twist knob.
‹
appears in the display for the heat setting.
4
Press the
¨
symbol in the control panel. An audible
signal sounds. The
¨
symbol lights up in the
display for the hotplate.
5
Press the
¨
symbol on the wireless temperature
sensor on the cookware. Once the wireless
temperature sensor has been detected, the default
temperature of 95 °C lights up in the hotplate
display.
6
Set the required temperature using the twist knob.
The temperature can be changed by increments of
5 °C.
1200 - 1400 m.
‰
above 1400 m.
Š
Height
Setting
™†
* Basic setting
X|
Y|
Â
