Gaggenau BS 464 610, Инструкция по использованию и уходу

Страница: 17 / 52

17
Activating the appliance
Standby
The appliance is in the standby mode when no function
is set or the child lock is activated.
The control panel's brightness is reduced in the standby
mode.
Notes
‒ There are various displays for the standby mode.
The GAGGENAU logo and the time are set by
default. Refer to the section entitled
Factory setting
if you would like to change the display.
‒ The display's brightness depends on the vertical
viewing angle. You can adjust the display by way of
the "Brightness" setting in the factory settings.
Activate appliance
In order to exit standby mode, you can either
▯
Set the function selector,
▯
Touch a control panel,
▯
or open or close the door.
Now you can set the desired function. Read the
appropriate chapters to learn how to set functions.
Notes
‒ If "Standby screen = off" is selected in the factory
setting, you must turn the function selector to exit
the standby mode.
‒ The standby display appears again if you have not
made any settings for a long while after activation.
‒ The cooking compartment lighting goes out after a
little while if the door is open.
Operating the appliance
Filling the water tank
When you open the appliance door, you see the water
tank at the side.
NOTICE:
Use of inappropriate liquids can damage the
appliance!
▯
Only use fresh tap water, softened water, or mineral
water without carbonation.
▯
If your tap water contains a lot of lime, we
recommend softened water.
▯
Do not use distilled water, highly chlorinated tap
water (> 40 mg/l), or any other liquids.
Information about your tap water can be obtained from
your water utility office. The hardness of your water can
be tested with the accompanying test strip.
Fill the water tank before every operation (except for
"Conv 30% Humidity", "Conv 0%
Humidity" and "Drying program"):
1 Open the appliance door and remove the water tank
(Figure A).
2 Fill the water tank with cold water up to the "max"
mark (Figure B).
3 Close the tank cover until it noticeably engages.
4 Completely push in the water tank (Figure C).
The tank must be flush with the tank slot (Figure D).
$
max
%
& '