GADLEE GT85 Series, Руководство оператора, Страница: 20 / 60

ENGLISH
10
whereas storage batteries with a lower capacity require recharges more frequently.
They must be kept charged, dry and clean, with their connections tight.
i INFORMATION
Follow the instructions below to set the type of battery installed on the machine's logic
board.
1. Switch off the machine by turning the key switch (fig. A, ref. 1) to the OFF position.
2. Hold the button (fig. A, ref. 5) down and switch on the machines by the turning the
key switch (fig. A, ref. 1) to the ON position, Keep the buttons pressed (fig. A, ref.
5) until "LANGUAGE" on the display.
3. Press the setting button (fig. A, ref. 5) to switch the display parameter, until the
"BATTERY TYPE" displayed
4. Using the "+" and "-" buttons (fig. A, ref. 2) to select the type of batteries: "WET"
or "AGM/GEL"
5. save the parameter and quit the setting menu by pressing and hold the setting
button (fig. A, ref. 5).
5.4.1 Batteries: preparation
!
DANGER
On installing or performing any kind of maintenance on the batteries wear the
necessary accessories (e.g. protective gloves, goggles, overalls, etc.) to limit the
hazards of accidents, keep away from possible free flames, do not short-circuit the
battery poles, cause sparks or smoke.
The batteries are normally supplied filled with acid and ready-for-use.
If batteries without acid are to be used, before mounting them on the machine, it is
necessary to make them active as follows:

After taking off the battery plugs, fill up all elements with a solution of specific
sulphuric acid, until the cells are thoroughly covered (fill each element at least twice);

Let them rest for about 4-5 hours, to give time to air bubbles to come up to the
surface and the plates to absorb the electrolyte;

Check that the electrolyte level is still above the plates, otherwise top up with the
solution of sulphuric acid;

Reclose the plugs;

Install the storage batteries on the machine (following the procedure described below).

It is now necessary to perform a first recharging before having the machine start; to
do so stick to the instructions written in the respective paragraph.
5.4.2 Batteries: installation and connection
!
DANGER
Check that the key switch on the control panel is at the position “0” (off).
Mind you connect only the clips marked with the symbol “+” to the positive poles.
Do not check the battery charge by creating sparkles.
Stick scrupulously to the instructions described below, as any short circuits of the
batteries may cause them to explode.
1) Stop the machine and press the emergency button (fig. A, ref. 1);
2) Make sure that the two tanks are empty (empty them, if necessary: see respective
paragraph);
3) Unhook the recovery tank (fig. B, ref. 2) from the solution tank (fig. B, ref. 1) acting on
the blocking hook (fig. B, ref. 10), placed on right side of the machine;
4) Lift the recovery tank, by making it turn backwards around about 90°: in this way you
have access to the battery compartment (embedded in the solution tank) from the
upper side;