39
10.6. ADVANCED: USING THE NETWORK SETUP WEBPAGE (AEROSPHÈRE BASE)
Figure 37: How to do the Wi-Fi setup with the network setup webpage.
Instructions
This setup method works with iPhone, iPad, Android, Mac and PC.
1. Turn the AeroSphère Base on by sliding the power switch to the ON position. Wait until you see the display flash
two times repeatedly in green. When you are using the AeroSphère Speaker for the first time, this mode is already
enabled. Skip step 2 - 4 and go to step 5.
2. After you turned the Base on, wait about 30 seconds.
3. If the display does
not
flash two times repeatedly in green, you can enable this Wi-Fi Setup manually:
Hold the “SETUP” button on the back for 10 seconds
, until the display starts flashing two times repeatedly in
green.
4. Wait 30 seconds.
5. A new temporary Wi-Fi network is now available (“AeroSphere_Base_SETUP…”). This temporary Wi-Fi network
is created by the AeroSphère Base and requires no password.
6.
Connect to the temporary Wi-Fi network
, depending on your device and operating system.
6 - 9. Follow steps 6 - 9 on the “Instructions" in the previous section for AeroSphère Small & Large.
10: The display will change from green (fast blinking) to green (slow blinking) with a successful connection. This
can take up to a minute. You are now successfully connected to your Wi-Fi network.
