REAR LIGHT »R-232 ND«
GB
Technical facts and references
u
With red COB LEDs (24 pcs), standlight via
capacitor
u
Tested and approved in accordance with
the German Road Traffic Licensing Regula-
tions (StVZO)
u
The reflector surface of the taillight must
be oriented vertically to the road and at a
right angle to the longitudinal axis of the
road.
u
Nominal performance: 0,6 W
u
Input voltage: 6V AC
PLEASE NOTE
If an LED fails, the entire light unit must
be replaced!
Important:
Rear-light and headlamp must only be
switched on at the same time in case they
are run by one alternator.
This rear-light should only be connected to a
frontlight with separate on and off techno-
logy.
Connecting the rear-light:
Pull the + and – slide-appliance out of the housing (1), insert the designated cables in the
particular port and then push the slide-appliance back into the housing again (2).
Atachment of the rear-light:
u
Mounting hight: 250-1200 mm
u
Attach the rear light with the designated
screws,nuts and washers to the carrier of
the bicycle.
u
When attaching the tail light, make sure
that the screws are tightened so tightly
that the light can not.
Before every
journey, en-
sure that the
headlight is
not covered.
1
3
2
vehicle`s longitu-
dinal axis
Screw:
M5 x 15
Power cable +
Power cable +
Power cable -
Power cable -
Slide
Slide
R-232
DC AC 6 V 0,6 W
R-232
DC AC 6 V 0,6 W
R-232
DC AC 6 V 0,6 W
R-232
DC AC 6 V 0,6 W
24 COB LED
Input
COB Ring rot (24 St.)
IA
150R00 0005
K 1759
K 1793
