Operators and Technicians Manual
2011 – 2014 FutureLogic, Incorporated. All Rights Reserved.
MNL Page 19 04/10/2014
MNL-000067 REV.X03
7.
Slide the COMM Switch back to Position 1 to accept and save the changes.
The LEDs blink in a sequence pattern for approximately 200 ms then return to normal. This indicates the
setting updates are now in use.
Note:
If the LED indicators illuminate at once, the module settings were not accepted. Repeat the
procedure. Additionally, print a Configuration Ticket to check the module setting.
COMM Switch Examples
To set the printer Main Port to communicate at 9600 Baud with Xon/Xoff handshaking:
1.
Slide the COMM Switch to Position 1. The Red LED flashes.
2.
Slide the COMM Switch to Position 2. The Red LED stops flashing, all lights are OFF.
3.
Slide the COMM Switch to Position 1.
To set the printer Secondary Port 2 to communicate at 57600 Baud with Xon/Xoff handshaking:
1.
Slide the COMM Switch to Position 1. The Red LED flashes.
2.
Slide the COMM Switch to Position 1 again. The Green LED turns on; the Red LED continues to flash.
The selection is now Port 2.
3.
Slide the COMM Switch to Position 2. All LED lights turn OFF.
4.
Slide or hold the COMM Switch for 8 more times. The LED lights will step through the settings
according to the Position 2 table. For 57600 with Xon, only the Red LED will be ON.
5.
Slide the COMM Switch to Position 1 to save this setting.
Remove the Memory/LED Module
WARNING!
To prevent damage to the Memory/LED Module or the printer circuit board, turn off
power to the printer before you remove or insert the Module.
1.
Disconnect power to the printer.
2.
Press the Lid Release Lever to open the Lid.
3.
Locate the Memory/LED Module to the right of the Print Head.
4.
Remove the two screws from the Module.
Figure 7-2
Memory/LED Module Screws
5.
Pull out the Module from the printer.
Figure 7-3
Pull Out Module
Screws
