00083755.DOC, Version 1.2
34/40
IR Setup
<On>
Control via IR remote
Default setting: On
<Off>
Dimmer Mode
<Off>
Dimmer speed (step response)
Off : Response characteristics of LEDs
DIM 1: Response characteristics of halogen lamps, fast
DIM 2: Response characteristics of halogen lamps,
middle
DIM 3: Response characteristics of halogen lamps, slow
Default setting: Off
<Dimmer 1>
<Dimmer 2>
<Dimmer 3>
Back Light
<On>
Display shutoff
On
：
LCD display always on
30S: Shuts off the display after 30 seconds
Default setting: On
<30S>
Information
Auto Test
Test
Testing program
Fixture running time
0-9999H (hours)
Software version
Fixture Hours
<9999>
Version <V1.0>
DMX Address
001-512
DMX address setting
Default setting
：
001
DMX Channel
<4Ch>
Setting DMX channel mode
4CH
：（
001-509)
6CH
：（
001-507
）
9CH
：
(001-504
）
12CH
：
(001-501
）
Limit the DMX address according to DMX channel mode
Default setting: 9 CH
<6Ch>
<9Ch>
<12Ch>
Master/Slave
<Master>
Master/Slave mode
Default setting: Slave
<Slave>
Wireless Setting
Receive
<On>
Activate W-DMX
De-activate W-DMX/activate
DMX via cable
Default setting:On
<Off>
Reset <Reset>
Logout from sender
White Balance
Balance Value
White balance
RGB Default setting: 255
<R=255> <R=255> R
：
125-255
<G=255> <G=255> G
：
125-255
<B=255> <B=255> B
：
125-255
Wireless Setting
From factory, this projector is prepared for wireless data transmission (WDMX). If you wish to de-activate
WDMX control, you can select the function
“Receive” – “Off”
. With the function
“Receive” – “On”
you can
log in the wireless receiver in to a wireless transmitter, the fixture could now receive the wireless DMX signal.
In order to control the device with a cabled DMX controller, set the function
“Receive“
to
”Off“
With the function
“Reset”
, you can log out the projector from the wireless sender.
