3.
Before the boat is placed into the water for operation, make sure that the
boat power and remote control power have both been switched on. In
addition, the spare battery of the remote controller should be equipped at all
times to prevent the boat from failing to return in case the controller loses
power.
4. Please do not use the boat overloaded with bait in adverse weather
conditions, check the inside of the boat frequently when operating in bad
weather.
5. Do not make the motor idle. If the motor shaft isn’t in the water, it cannot be
cooled. The heat due to friction with the water seal will make it quickly age
and degrade the water proof performance.
6. The valid distance of the remote controller signals is 400m. The valid distance
of the remote controller signals may be shortened due to influences of the
environment and other factors. Please operate the boat within the range of
visibility as much as possible during operation. When the remote control
signals are lost or the remote controller is turned off, the boat will
automatically stop in the water (the boat based on GPS auto-pilot can
automatically return to the origin) and four front and rear lights will flicker
continuously at the same time. In addition, the boat and remote controller
antenna shall all point to the sky, so that transmission and receiving effect of
the signals is optimal.
7. When the boat power alarm indicator is turned on, the boat can continue
navigation for about 15 minutes. When the alarm indicator starts to flicker
(GPS auto-pilot boat can automatically return to the origin), please stop
operation immediately and charge the boat batteries. (Please stop using the
