Ver.1.1
27
8.3 Commands
The host system communicates to the FDP02 by below command.
8.3.1 List of commands
The table below shows the commands.
Command
Function
Remark
ARG
Show the settings of all registers.
BCL
Clear transmission and reception buffers.
DAS
Show/set the destination address.
FNU
Show/set the frequency group.
Groups (1 to 3)
FRQ
Show/set the frequency channel.
Frequencies (02 to 81)
IDR
Show ID code
IDW
Set ID code
INI
Initialize all memory registers.
RST
Reset the FDP02.
REG
Show/set the memory register
REG00 to REG26
POF
Release low power stand-by mode
PON
Set low power stand-by mode
PTE
Show/Set extended stand-by time
PTN
Show/Set stand-by time
PTS
Show/Set sleep time
ROF
RF circuit OFF
RON
RF circuit ON
TBN
Transmit binary data.
TID
Show the serial number.
TS2
Execute a communication test.
TXT
Transmit text data.
VER
Show version information.
8.3.2 Command input format
The input format of a command is as follows:
@xxxx<Cr><Lf> @: Command header
xxxx: Command code
<Cr>: Carriage return code
<Lf>: Line feed code
If multiple commands are entered continuously, the commands that are entered
before the response from the FDP02 is ignored. Therefore, it should be entered
after the FDP02 returns a response for previous command.
