75
＜
Linkage Menu
＞
HELI
COPTER
AIRPLANE
GLIDER
LINKAGE MENU
The Linkage Menu has all of the functions you will
need to perform model addition, model type selection,
frequency setting, end point setting, and other model
basic settings.
The functions which can be selected depend on which
model type you are using. A typical menu screen is
shown below.
Linkage Menu functions table
●Servo Monitor:
Displays the servo test and operation position
●Model Select:
Model addition, call, deletion, copy, model name setting
●Model Type:
Model type, wing type, switch type, etc. selection
●Picture:
Picture selection and setting for each model
●Sound:
Sound recording and playback
●System Type:
System selection, receiver link, telemetry.
●Function:
Channel assignment of each function can be changed
●Sub-Trim:
Adjusts the neutral position of each servo
●Servo Reverse:
Servo direction reversal
●Fail Safe:
Fail safe function and battery fail safe function setting
●End Point (ATV):
Servo basic rudder adjustment and limit setting
●Throttle Cut:
Stops the engine safely and easily (airplane and helicopter only)
●Idle Down:
Lowers the idle speed of the engine (airplane and helicopter only)
●Swash Ring:
Limits the swash travel within a ixed range to prevent linkage damage (helicopter only)
●Swash:
Swash AFR and linkage correction function (helicopter only)
●Timer:
Timer setting and lap time display
●Dial Monitor:
Dial, slider, and digital trim position display and setting
●Function Name:
Function Name can be changed
●Telemetry:
Displays various data sent from the receiver
●Sensor:
Various telemetry sensors setting
●Sensor Name:
Change of a sensor name
●Telemetry Setting:
Data logging of telemetry
●Warning:
Warning sound and vibration setting
●Data Reset:
Model memory data reset (by various item)
●User Menu:
Create an original menu that you often use
Содержание 32MZ
Страница 1: ...1M23Z06801 INSTRUCTION MANUAL...