37
＜
Basic Operation
＞
How to turn ON/OFF the
power of the transmitter
Windows
®
Embedded Compact 7 is installed as a
built-in operating system in the T32MZ transmitter.
Compared to the conventional system, the T32MZ
takes extra time for internal processing when it is
turned on/off.
When turning on the power of the transmitter
1. Place the throttle stick below 1/3 closed.
2. Turn on the power switch.
*After initialization of the transmitter is complete,
the LED monitor turns Purple.
*If your throttle stick is not at 1/3 closed or fully
closed, a warning will sound. If you move the
throttle to 1/3 closed or fully closed, the warning
will stop and will become a "Transmit
?
" screen.
*If you push the button "NO", then the transmitter
will not emit radio waves.
*If you push the button "Yes", then the transmitter
will emit radio waves.
*If a battery is removed and it re-connects, please
switch on a power supply, after 3 seconds or more
pass.
Start-up time;
The time required to initialize the internal circuit
of the transmitter varies between the previous time
you turned the power off and then restarted the
transmitter. There are two “start up” modes for your
transmitter, see below:
Cold start;
If you turn on the transmitter more than four hours
after you last turned it off, the mode is “Cold start”.
“Cold start” is normal for the irst initial power up
of the day. It will take about 30 seconds to be ready
for use, as it takes time to initialize the internal
circuit of the transmitter.
Hot start;
If you turn on the transmitter less than four hours
after you last turned it off, the mode is “Hot start”.
Since initialization has been partly completed, the
transmitter will be ready to use in several seconds.
Since initialization has been partly completed, the
transmitter will be ready to use in several seconds.
“Hot start” takes place usually at a second light or
later light in the day.
WARNING
Once you turn on the power, never shut off the
power switch until the power becomes stable (or
until the irst screen shows up). If you turn off
the power switch while the transmitter is going
through the initialization process, the data could
be damaged.
Note:
The start-up time may be a little bit
slower when the microSD card is installed
compared to when the card is not.
How to stop the transmitter
Turn off the power switch of the transmitter. The
internal circuit of the transmitter starts the shut
down process including saving the set-up data.
Once you turn off the power, never operate the
power switch until the power shutdown process
is fully completed. If you turn on the power
switch again while the transmitter is still in the
process of power shutdown, the data could be
damaged.
The center switch
is pushed.
Push and hold
the center
switch.
BASIC OPERATION
How to reset software
If the screen freezes for some reason and you
cannot edit, the transmitter power supply is not
fully off even if you turn OFF the power switch.
You will need to remove the battery and reinsert
it again. In this case, the power restarts in “Cold
mode”. Even though the screen freezes, all the
other functions for radio control operation remain
operative.
Содержание 32MZ
Страница 1: ...1M23Z06801 INSTRUCTION MANUAL...
