8. INSTALLATION
8-13
8.2.4
How to connect the Cable Replacement Kit (OP20-50)
Use a waterproof relay box (JPBS06) to relay connection when connecting to the GS-
1001B with the MJ-A10SPF0015-150C/300C cable used in GS-1001.
1) Unfasten four washer head screws on the top of the waterproof relay box to re-
move the cover.
2) Fabricate the MJ-A10SPF0015-150C/300C as follows.
1) Cut the MJ-10 connector part. Expose inner vinyl sheath by approx. 40 mm. Be
careful not to damage inner shield and cores.
2) Cut unused wires (green, yellow and purple) to approx. 10 mm, then isolate
them with vinyl tape. Wrap the drain wire with a vinyl tube.
Note:
Make sure the rubber bush and ring are oriented correctly (as shown in
the figure above).
40 mm
40 mm
40 mm
Rubber Bush (Large)
䚷
+ Ring
Rubber Bush (Large)
䚷
+ Ring
10 mm
10 mm
10 mm
Wrap the drain wires with the vinyl tube.
Wrap the drain wires with the vinyl tube.
Vinyl tape
Vinyl tape
Cap
Cap
Содержание GS-100
