Furuno FM-8800, Руководство по обслуживанию

Страница: 131 / 268

4.7
μ
TP-80F Setup
4-35
1. DIP Switch Setting
The factory setting is the meshed state of Table 1 and 2.
Switch #2 switches between normal and reversed characters. When you switched the
DIP switch, turn on the power again.
Table 4.7.1 Function of DIP Switch
Function/Switch No. 1 2 3 4 5 6 7 8 9 10
Small character size ON
Normal character size OFF
Reversed character ON
Normal character OFF
Pitch (22 lines) ON
Pitch (20 lines) OFF
International character See Table 2.
Alpha Calibration
See
Table 3.
Automatic line feed ON
Not
used
NOTE;
For test printing:
1. Turn on the printer while pressing and holding down FEED switch.
2. All characters are printed out and then five line pattern is printed.
The printer is on-line after test printing.
- In case of PE during the test printing, returns to the state of PE after printing a line.
- To cancel the test printing, press SEL switch. It stops printing and changes to ON
LINE in a few moments.
Value 7 8
0 OFF OFF
-1 OFF ON
+1 ON OFF
+2 ON ON
Table 4.7.2 International character setting Table 4.7.3 Alpha Calibration
Character 4 5 6
Japan OFF OFF OFF
US OFF OFF ON
German OFF ON OFF
English OFF ON ON
French ON OFF OFF
Spanish ON OFF ON
Italian ON ON OFF
Swedish ON ON ON
* These switches are used for
mechanical calibration.
The value differs from set to set.