Furuno FCR-2119-BB, Руководство по эксплуатации

Страница: 68 / 541

2. RADAR, CHART RADAR OPERATION
2-2
2.2.3 Manual tuning
To tune the radar, start by setting the brilliance to a comfortable level, adjusting the
gain until the background speckle just disappears, and selecting the 48 NM range.
Then, do the following:
1. Choose a weak contact somewhere near the edge of the screen and concentrate
on that, while adjusting the gain control in small steps - allowing at least two sec-
onds between each step - until the chosen contact is as big, bright and consistent
as possible.
2. Click the [TUNE] button on the InstantAccess bar™ to display [TUNE MAN].
3. Put the cursor on the tuning bar.
4. Spin the scrollwheel to tune. The best tuning point is where the bar swings maxi-
mum. The arrow below the bar shows the tuning control position; not the tuning
condition.
2.3 Pulse Length
The pulse length in use is displayed at the top-left position on the screen, using the
indications shown in the table below.
Appropriate pulse lengths are preset to individual range scales and function keys. If
you are not satisfied with the current pulse length settings, you can change them as
shown below.
2.3.1 How to select a pulse length
You can select the pulse length for the 0.5 to 24 NM range
scales as shown below.
1. Open the menu then select [1 ECHO], [1 CUSTOMIZE
ECHO] and [8 PULSE] menus to show the [PULSE]
menu.
2. Do one of the following:
Control Unit : Press appropriate numeric key to select
corresponding item number.
Trackball module : Click appropriate item.
3. Select desired option by pressing the numeric key
pressed at step 2 or spinning the scrollwheel.
4. To confirm selection, press the ENTER key on the Con-
trol Unit, or push the left button.
Pulse length indication Pulse length (
P
s)
S1 0.07
S2 0.15
M1 0.3
M2 0.5
M3 0.7
L 1.2
1 0.5NM
S1 / S2
2 0.75NM
S1 / S2 / M1
3 1.5NM
S1 / S2 / M1
4 3NM
S2 / M1 / M2 / M3
5 6NM
M1 / M2 / M3 / L
6 12-24NM
M2 / M3 / L
ECHO
CUSTOMIZE ECHO
← PULSE
MENU