Furuno FCR-2119-BB, Руководство по эксплуатации

Страница: 28 / 541

1. OPERATIONAL OVERVIEW
1-2
Control Description
Turns the system on or off. (With a FURUNO monitor unit, the monitor is also
turned on or off with this switch.)
Status LED The color and state of the LED change according to system or alert status.
Green, lighting : Normal operation status; no alerts generated.
Green, flashing : The heater on the CPU board is on, because ambient tem-
perature is not at least 0°C. The heater takes about two minutes to warm the
equipment. The LED lights green after the heater goes off.
Red, lighting : Acknowledged alert or SYSTEM FAIL. SYSTEM FAIL occurs
when there is trouble in the Processor Unit or communication failure between
the Processor Unit and a Control Unit. Each Control Unit detects trouble and
its lamp flashes in red and the buzzer sounds. If this condition occurs at the
No. 1 Control Unit, the SYSTEM FAIL signal is output.
Red, flashing : Unacknowledged alert or SYSTEM FAIL.
Rotary control
EBL1, EBL2 Rotary control : Rotates the active EBL.
EBL1, EBL2 : Activates or deactivates the respective EBL.
ALARM ACK • Silences the aural alarm.
• Acknowledges unacknowledged alert.
InstantAccess
knob Selects the buttons on the InstantAccess bar™.
ESC Goes back one step in current operating sequence on the InstantAccess
bar™.
BRILL Rotate : Adjusts the brilliance of the display (FURUNO-supplied monitor only).
Push : Selects a color palette.
A/C RAIN Rotate : Suppresses rain clutter.
Push : Toggles between manual and automatic rain clutter adjustment.
A/C SEA Rotate : Suppresses sea clutter.
Push : Toggles between manual and automatic sea clutter adjustment.
GAIN Adjusts the sensitivity of the radar receiver.
HL OFF • Temporarily erases everything but radar echoes when held down.
• Enters the numeric 1.
• Selects like-numbered menu item.
OFFSET EBL • Activates or deactivates the offset EBL.
• Enters the numeric 2.
• Selects like-numbered menu item.
MODE • Selects a presentation mode.
• Enters the numeric 3.
• Selects like-numbered menu item.
STBY TX Toggles the radar between standby and TX.
OFF CENTER • Re-centers radar position at the cursor location.
• Enters the numeric 4.
• Selects like-numbered menu item.
CU/TM RESET • Course-up : Resets heading line to 000°.
• True motion : Moves own ship position 75% of the radius in stern direction.
• Enters the numeric 5.
• Selects like-numbered menu item.
INDEX LINE • Selects an index line (in the PI line box).
• Long press to activate or deactivate selected index line.
• Enters the numeric 6.
• Selects like-numbered menu item.
MENU Opens, closes the menu.