1. MOUNTING
1-7
8. Install grease cotton on the main body as below.
a) Wind grease cotton onto main shaft.
b) Mark on the cotton as below.
c) Remove the cotton from the shaft, and then cut it at the position of the mark.
Discard the ends.
d) Wind grease cotton as shown below.
e) Push grease cotton into the main body flange.
f) Tighten the grease cotton retainer.
Setting grease cotton
9. Attach the tank guide.
Installing the tank guide
Flat washer
Position joints of cotton 120° apart and
push them into main body flange.
Tighten grease cotton retainer
for a gap of 7 to 9 mm.
Bow mark
Mounting location for tank
M10
Spring
washer
*: Measure between the topof the transducer flange
and inneredge of the tank guide.
M10×55
Align with bow mark on transducer.
Tank guide
107 kHz
85 kHz
312 mm
288 mm
112 mm
88 mm
400
600
Travel type
TX frequency
Содержание CSH-8LMARK-2
