Furuno CSH-8LMARK-2, Руководство по установке

Страница: 32 / 85

2. WIRING
2-6
2.3.1 Transducer cable wiring
Separate the cable in two, pass it through cable clamp [A] and fix it with a cable tie.
Pass the cable through cable clamp [B] and fix with cable tie. Pass cable through cable
clamp at the side of the transceiver unit.
Transceiver unit, upper view
Note 1: Wire unit with cable clamps in horizontal position. Lay cable clamp after fin-
ishing wiring.
1) Lay braided shields of
transducer cable in cable
clamp. Each cable is num-
bered; connect referring to
the illustration on the pre-
ceding page.
2) Unfasten two bolts.
3) Set the clamp and fasten it
with two bolts removed at
step 2.
Note 1: When fixing transduc-
er cable with cable clamp, wrap with vinyl tape before fixing, or wrap the cable with a
piece of the outer sheath of the cable and fix by cable clamp.
2.3.2 Power cable
Fabrication of power cable
Note: When connecting the power cable, the crimp on lug of the capacitor is removed.
Do not forget to reattach the crimp on lug of the capacitor to the terminal board.
Cable clamp
(See Note 2.)
(Can be placed
on left side.)
Transducer cable
Fix by two cable ties.
Cable clamp [B] Cable clamp [A]
Fix by cable clamp.
(See Note 1.)
Clamp base
Clamp
Bolts
40
5
100
1
2
FV5.5-4 TB-B1
Vinyl sheath
Armor