5
SECTION 1: SCOREBOARD SETUP
1.
If you are using a wireless keypad, make sure it is fully charge before using your scoreboard. Refer to
Section 10 for charging instructions.
2.
If you are using the scoreboard without an AC adapter, remove/open the battery cover(s) located on
the rear of the scoreboard and install six AA-size alkaline batteries (SNT-140 series) or 8 C-cell
alkaline batteries (SNT-440 series). Re-attach/close the battery cover(s).
3.
Extend the support stand/legs as shown below:
SNT-140 series support legs
SNT-440 series support stand
4.
Use the optional AC adapter if operating the scoreboard near an electrical outlet to conserve batteries.
NOTE: If you are using the scoreboard outdoors, aim the display away from the sun for best
visibility.
5.
Place the scoreboard in a desired location near your playing field. The best location is mid-court on
the sidelines. This will provide the best view of the display. It can also be placed in the corner of the
playing field, as long as everyone in the opposite corner of the field can view it and is within radio
range of the keypad.
6.
Select the display brightness by pressing and holding the GUEST
button for approximately 3
seconds. Each press and hold of this button will toggle between the low, mid, and high brightness
levels.
7.
You are now ready to use your scoreboard. Proceed to Section 2 for using the various operating
modes. Additional modes of the SNT-140P/440P scoreboard are detailed in Section 3.
