Rev. 03
10.2 Connection Scheme
- Base Module
Fastening the base module with screws*;
Panel
91mm
45mm
To place the frontal module
on the control panel, press
until it engages;
2
To release it, just press the side
locks;
3
Remove the controller
from the front control
panel;
10. INSTALLATION
10.1 Fastening of frontal and base modules
- Frontal Module
Make the cut in the control panel by taking
the given measures. Please refer to item 3;
1
ENVIRONMENTAL INFORMATION
Packaging:
The materials used in Full Gauge products' packaging are 100% recyclable. Dispose of your
waste preferably using specialized recycling agents.
Product:
The components used in Full Gauge controllers can be recycled and reused if disassembled
by a specialized company.
Disposal:
Do not burn or throw controllers in domestic garbage. Obey the laws in effect for your area
regarding the disposal of electronic waste. If in doubt, please contact Full Gauge Controls.
11. IMPORTANT
According to the chapters of the NBR 5410 regulations:
1:
Install overvoltage protectors at the power supply
2:
Sensors and serial communication cables can go together, but not in the same conduit
through which power supply and charge activation pass.
3:
Install transient suppressors (RC filter) parallel to the charges in order to increase the life of
the relays.
Suppressors wiring diagram on
contactors
Suppressor
A1
A2
A1 and A2 are the terminals
of the contactor coil.
Suppressors wiring diagram on direct
activation charges
Load
Suppressor
For direct activation, consider
the maximum current specified.
Full Gauge Controls offers suppressors for sale
* The
S1 sensor
must be in the ambient (black).
**The
S2 sensor
must be secured on the evaporator
by the metallic clamp (gray).
- Base Module
- Frontal Module
(Power supply and common
of the relays)
Light
(LIGHT)
Compressor
(COMP)
Defrost
(DEFR)
Power supply
115 Vac
(or in the version
230 Vac)
Fan
(FANS)
Interconnection Cable
Sensor S1*
Sensor S2**
Digital input
(Door Switch)
*screws not included;
Copyright 2014
W
ARRANTY
- FULL
GAUGE CONTROLS
Products manufactured by Full Gauge Controls, as of May 2005, have a two (02) year
warranty, as of the date of the consigned sale, as stated on the invoice. They are guaranteed
against manufacturing defects that make them unsuitable or inadequate for their intended use.
EXCEPTIONS TO WARRANTY
The Warranty does not cover expenses incurred for freight and/or insurance when sending
products with signs of defect or faulty functioning to an authorized provider of technical support
services. The following events are not covered either: natural wear and tear of parts; external
damage caused by falls or inadequate packaging of products.
LOSS OF WARRANTY
Products will automatically lose its warranty in the following cases:
- The instructions for assembly and use found in the technical description and installation
procedures in Standard IEC60364 are not obeyed;
- The product is submitted to conditions beyond the limits specified in its technical description;
- The product is violated or repaired by any person not a member of the technical team of Full
Gauge Controls;
- Damage has been caused by a fall, blow and/or impact, infiltration of water, overload and/or
atmospheric discharge.
USE OF WARRANTY
To make use of the warranty, customers must send the properly packaged product to Full
Gauge Controls together with the invoice or receipt for the corresponding purchase. As much
information as possible in relation to the issue detected must be sent to facilitate analysis, testing
and execution of the service.
These procedures and any maintenance of the product may only be provided by Full Gauge
Controls Technical Support services in the company's headquarters at Rua Júlio de Castilhos,
250 - CEP 92120-030 - Canoas - Rio Grande do Sul – Brasil
