En-3
21
22
23
24
20
17
18
19
NAME OF PARTS
Display panel
To facilitate explanation, the accompanying illustration
has been drawn to show all possible indicators; in ac-
tual operation, however, the display will only show those
indicators appropriate to the current operation.
●
This button is used when installing the condi-
tioner, and should not be used under normal
conditions, as it will cause the air condition-
er’s temperature function to operate incor-
rectly.
●
If this button is pressed during normal opera-
tion, the unit will switch to test operation
mode, and the receiver unit control panel’s
OPERATION Indicator Lamp (green) and
TIMER Indicator Lamp (orange) will begin to
flash simultaneously.
●
To stop the test operation mode, press the
“START/STOP” button to stop the air condi-
tioner.
Remote controller
16
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
Display
1
“MODE” button
2
“SET TEMP. (
/
)” button
3
“10 °C HEAT” button
4
“ECONOMY” button
5
“SLEEP” button
6
“FAN” button
7
“START/STOP” button
8
“ SET” button (Vertical)
9
“ SET” button (Horizontal)
0
“ SWING” button
A
“TIMER MODE” button
B
“TIMER SET (
/
)” button
C
“CLOCK ADJUST” button
D
“RESET” button
E
“TEST RUN” button
F
Signal Transmitter
G
Temperature SET Display
H
Operation Mode Display
I
SLEEP Display
J
Transmit Indicator
K
Fan Speed Display
L
SWING Display
M
Timer Mode Display
N
Clock Display
Some indoor units may not be equipped with the func-
tions corresponding to all of the buttons on this remote
controller. The indoor unit will beep and the OPERATION,
TIMER and ECONOMY lamp flash when a remote con-
troller button is pressed if the function is not available.
9378629042_OM_en.p65
21/9/10, 17:00
3
