Fujitsu SPARC Enterprise M8000, Руководство по обслуживанию

Страница: 302 / 562

13-20 SPARC Enterprise M8000/M9000 Servers Service Manual • October 2012
b. Push the PCI card until the notched part on the base plate of the PCI card
touches the card-positioning tab from the PCI cassette.
Note –
When affixing the PCI card after aligning its position with the card-positioning tab,
do so while pulling the lever about 2 cm from the frame.
c. Align the PCI card with the center part of the lower latch of the cassette. Then,
while pressing the PCI card against the center part of each of the upper latches of
the cassette, tighten the fixing screws in the sequence shown in
FIGURE 13-8
to fix
the card in position.
Caution –
If the card is short, move the screw at the bottom of the cassette as required. In
such cases, place the latch as close as possible to the far end of the card. See
FIGURE 13-9
.
9. Mount the PCI cassette.
a. Pull the lever of the PCI cassette until the PCI cassette is pulled out completely.
b. Align the PCI cassette with the groove of the PCI slot, and insert the PCI cassette.
c. Press the upper part of the cassette until the cassette is inserted in the same
position as the other cassettes.
d. Push in the lever.
e. Using a Phillips screwdriver, tighten the green screw.
Caution –
Align the PCI card with the slot guides, insert it carefully, and secure it firmly.
Caution –
Do not forcibly push the PCI card when inserting it, even if it is not moving
smoothly. You may fail to insert the PCI card due to the presence of any obstruction in a slot
or any problem with a connector pin; and if you forcibly insert it, serious damage may result.
If the lever of a PCI cassette cannot be inserted
a. When the lever of the PCI cassette is pushed in but it stops halfway without
reaching the far end, do not forcibly push it in any further. Instead, pull it out
once and then insert it again. (See
FIGURE 13-11
)