53
CHAPTER 2 DEPENDENCE FUNCTIONS
2.1.11.1
Setting Trace
You must set the following two items to perform a trace. After that, trace data will be
sampled with the execution of the program.
■
Setting Trace
1. Enable the trace function. This program will startup and will be enabled.
•
Dialog
This is done by [Setup] - [Trace] in the trace window shortcut menu.
•
Command
Enter the ENABLE TRACE command.
2. Set the trace buffer full break. When the trace buffer is full, you can make a break. When starting up this
program, it is setup for no breaks.
•
Dialog
This is done using the trace window shortcut menu [Setup] - [Trace].
•
Command
Enter the SET TRACE/BREAK command.
Содержание SOFTUNE F2 MC-16
