Fujitsu PRIMERGY TX300 S7, Руководство по модернизации и обслуживанию, Страница: 819 / 898

TX300 S7 / RX350 S7
Upgrade and Maintenance Manual 819
System board and components
14.5.5 Concluding steps
Ê
Reconnect all remaining cables to the system board. For a complete cabling
overview, please refer to section
"Cabling overviews" on page 851 .
Ê
Reinstall all remaining system board components as shown in the related
sections:
– Heat sinks: refer to section "Installing processor heat sinks" on page 588
– Memory modules: refer to section "Installing a memory module" on
page 539
I
Install all memory modules into their original slots.
– Expansion cards: refer to section "Installing a memory module" on
page 539
I
Install all expansion cards into their original slots.
– UFM board: refer to section "Installing the UFM board" on page 759
– TPM board (if applicable): refer to section section "Installing the TPM
board" on page 773
Ê
Reinstall all fan modules and fan holders as described in the related
sections:
– "Installing the system fan holder" on page 379
– "Installing system fan modules" on page 375
– "Installing the rear fan holder" on page 393
– "Installing rear fan modules" on page 381
Ê
Reinstall the air duct as described in section "Installing the system air duct"
on page 94 .
Ê
Close the side / top cover as described in section "Mounting the top cover"
on page 107 (rack server) or "Mounting the side cover" on page 114 (tower
server).
Ê
If applicable, activate TPM functionality in the system BIOS under Security >
TPM (Security Chip) Setting > Security Chip . For more information, refer to the
"D2949 BIOS Setup Utility for PRIMERGY TX300 S7 / RX350 S7 /
TX120 S3 Reference Manual".