Fujitsu LifeBook P-2040, Руководство пользователя

Страница: 65 / 92

57
T r o u b l e s h o o t i n g
The display goes blank by
itself after you have been
using it. The notebook has gone into
Video timeout, Standby mode,
Suspend mode or Hibernation
mode because you have not
used it for a period of time. Press any button on the keyboard, or move the
mouse to restore operation. If that fails, push the
Suspend/Resume button. Check your power
management settings, or close your applications
and go to the Power Savings menu of the setup
utility to adjust the timeout values to better suit
your operation needs. (See BIOS Setup Utility on
page 27 for more information)
Something is pushing on the
Closed Cover switch. Check the Closed Cover switch. (See figure 2-4 on
page 6 for location)
The power management time-
outs may be set for very short
intervals and you failed to
notice the display come on
and go off again. Press any button on the keyboard, or move the mouse
to restore operation. If that fails, push the Suspend/
Resume button. (The display may be shut off by
Standby Mode, Auto Suspend or Video Timeout)
The Built-in Display does
not close. A foreign object, such as a
paper clip, is stuck between the
display and the keyboard. Remove all foreign objects from the keyboard.
The Built-in Display has
bright or dark spots. If the spots are very tiny and
few in number, this is normal
for a large LCD display. This is normal; do nothing.
If the spots are numerous or
large enough to interfere with
your operation needs. Display is faulty; contact your support representative.
The application display
uses only a portion of your
screen and is surrounded
by a dark frame. You are running an application
that does not support 800 x
600/1024 x 768 pixel resolution
display and display compres-
sion is enabled. Display compression gives a clearer but smaller
display for applications that do not support 800 x
600/1024 x 768 pixel resolution. You can fill the
screen but have less resolution by changing your
display compression setting, (See the Video Features
submenu, located within the Advanced menu of the
BIOS. (See BIOS Setup Utility on page 27 for more
information)
The Display is dark when
on battery power. The default is set on low
brightness to conserve power. Press [Fn] + [F7] to increase brightness and adjust
Power Control under battery settings.
You have connected an
external monitor and
it does not display
any information. Your BIOS setup is not set to
enable your external monitor. Try toggling the video destination by pressing [Fn]
and [F10] together, or check your BIOS setup and
enable your external monitor. (See the Video Features
submenu, located within the Advanced Menu of the
BIOS. (See BIOS Setup Utility on page 27 for more
information)
Your external monitor is not
properly installed. Reinstall your device. (See Mini-VGA Port on page 46
for more information)
Your operating system soft-
ware is not setup with the
correct software driver for
that device. Check your device and operating system
documentation and activate the proper driver.
Problem Possible Cause Possible Solutions