Fujitsu LifeBook B2620, Руководство пользователя

Страница: 24 / 120

18
L i f e B o o k B S e r i e s – S e c t i o n T w o
Dragging
Dragging means touching the screen with the stylus,
moving and then lifting the stylus. To drag, tap the
Touch Screen twice with your stylus over the item you
wish to move, making sure to leave your finger on the
screen after the final tap. Next, move the item to its new
location by moving the stylus across the screen, and then
lifting the stylus to release it. Dragging can also be done
using your fingertip.
(Figure 2-19)
Figure 2-19 Dragging on the Touch Screen
Right-clicking
It is possible for you to perform right-click functions
with the stylus.
1. Click Start -> Programs -> Fujitsu Touch Panel
-> Touch Panel Configuration.
2. When the Right Button Tool screen appears, select
either "Hold [Ctl] key down and touch the screen"
or "Press [Ctl] key and touch the screen".
When you select "Hold [Ctl]...", the stylus will act as
a right mouse button when you hold down the
control key while touching the screen.
When you select "Press [Ctl]...", pressing the control
key before touching the screen will cause the stylus
to act as a right mouse button.
3. Click [Apply] to complete your selection.
Calibrating the Touch Screen
In order to ensure accurate tracking between the stylus
and cursor, you must run the Touch Screen Calibration
Utility before you use the Touch Screen for the first time,
or after you change the display resolution.
To run the calibration utility:
1. On the Start menu, point to Programs . Point to
Fujitsu Touch Panel/CTouch Screen Calibration
Utility
. This will open the Calibration Utility.
2. Adjust the display of your notebook to a comfortable
angle and find the red ( +) symbol in the upper-left
corner of the display.
3. Using the stylus, firmly touch the screen directly on
the ( +) symbol, then pause for a moment. When you
lift the stylus tip, the (+) symbol will move to the
next location.
4. Repeat step 3 until you have selected a total of twelve
symbols. This is the minimum number of points
necessary to calibrate your touch screen.
5. Once you have selected the twelve symbols, press
[ENTER], then press [ENTER] again.
P O I N T
Parameters for the Touch Screen can be adjusted from
the Mouse Properties dialog box located in the
Windows Control Panel.
P O I N T
If you receive an error message at this point, you
selected fewer than twelve symbols. Click
[OK] and
begin again at Step 2.
B Series.book Page 18 Thursday, September 26, 2002 11:01 AM